![]() ![]() Set Width to 3200mm (126 inches) and Height 25mm(1 inch) less than the maximum vinyl size accepted by your vinylcutter. This will create a an extra Com orUSB port that you can select in the SignTools 'Device Setup' dialogbox.CorelDraw SettingsIn CorelDraw's Layout menu select Page Setup. If you are unsure if your cable is a RS232-Ccable, contact your plotter distributor.USB ConnectionIf you are connectingyour cutter via a USB connection you must install the USB driverthat came with your cutter first. Select your vinyl cutter/plotter model from the 'Device'drop down boxand select your port.If you are using a Serial (Com) port click on the “Settings”button and set the following settings:-Bits per second: 9600Data bits: 8Parity: NoneStop bits: 1Flow Control: HardwarePlease check your plotter's manual and/orthe Com settings on the plotter's control panel and ensure that theymatch the settings in SignTools.Serial Plotter CablePlease ensurethat your Serial (Com) cable is a RS 232-C cable.SignTools will not communicate with your plotterwith a different cable. ![]() Jinka JK721 Vinyl Cutter Setup instructionsSignTools SettingsAfterinstalling CorelDRAW the next step is to install SignTools.Follow the instructions on 4 and 5 of the SignTools 4 User Guide.Once you have installed SignTools, open Corel Draw and click on theApplication Launcher (see picture below) and choose SignTools4.Next click on the 'Cut' button and then the 'Setup'button. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |